I use nftables to set my firewall rules. I typically manually configure the rules myself. Recently, I just happened to dump the ruleset, and, much to my surprise, my config was gone, and it was replaced with an enourmous amount of extremely cryptic firewall rules. After a quick examination of the rules, I found that it was Docker that had modified them. And after some brief research, I found a number of open issues, just like this one, of people complaining about this behaviour. I think it’s an enourmous security risk to have Docker silently do this by default.

I have heard that Podman doesn’t suffer from this issue, as it is daemonless. If that is true, I will certainly be switching from Docker to Podman.

  • Adam@doomscroll.n8e.devEnglish
    82·
    8 months ago

    Documentation people don’t read

    Too bad people don’t read that advice

    Sure, I get it, this stuff should be accessible for all. Easy to use with sane defaults and all that. But at the end of the day anyone wanting to using this stuff is exposing potential/actual vulnerabilites to the internet (via the OS, the software stack, the configuration, … ad nauseum), and the management and ultimate responsibility for that falls on their shoulders.

    If they’re not doing the absolute minimum of R’ingTFM for something as complex as Docker then what else has been missed?

    People expect, that, like most other services, docker binds to ports/addresses behind the firewall

    Unless you tell it otherwise that’s exactly what it does. If you don’t bind ports good luck accessing your NAT’d 172.17.0.x:3001 service from the internet. Podman has the exact same functionality.