• ShadowRam@kbin.social
    link
    fedilink
    arrow-up
    1
    ·
    10 months ago

    No, that’s interference from a higher current source.
    Most likely your stepper motor wires run in series with the thermistor.

    • atocci@kbin.socialOP
      link
      fedilink
      arrow-up
      1
      ·
      10 months ago

      Looking at how the wires are plugged in, you might be on to something here. The extruder stepper seems to be wired into the same port as the breakout board that the thermistor is connected to. If that is the problem though, any ideas how can I fix it and why it’s only showing up now? I’ve had this printer for maybe 2 years now and I installed klipper on it last month, but this issue only began a few days ago.

        • atocci@kbin.socialOP
          link
          fedilink
          arrow-up
          1
          ·
          10 months ago

          I replaced the hot end assembly a couple weeks ago, but I didn’t make any changes to the way things were wired. I plugged it in to the same connectors as before.

            • atocci@kbin.socialOP
              link
              fedilink
              arrow-up
              1
              ·
              10 months ago

              Yeah the exact same, it was the spare that came with the printer. I had messed up the original a little while ago when I changed out the nozzle from a V6 to a MK8 before I knew they were meant for different hot ends. The threading was the same and I thought that meant they were compatible… It had plastic leaking from around the heater block after that and after not using the printer for a bit, I did some research into where I went wrong and how to swap the parts out for the clean spare.

              • ShadowRam@kbin.social
                link
                fedilink
                arrow-up
                1
                ·
                edit-2
                10 months ago

                Sorry, I’m a little confused.

                So you attempted to replace the nozzle or the hotend at first?

                and when you had a problem you replaced the hotend?

                • atocci@kbin.socialOP
                  link
                  fedilink
                  arrow-up
                  1
                  ·
                  10 months ago

                  Yeah that’s right, I bought the wrong nozzle and using it messed up my hotend. Replacing the whole hotend at that point was easier than trying to clean the plastic out from all the places it had leaked into.

                  • ShadowRam@kbin.social
                    link
                    fedilink
                    arrow-up
                    1
                    ·
                    10 months ago

                    Alright, well then I wouldn’t rule out a very loose connection at the thermistor then.

                    1. I’d probably test the thermistor’s reading with no steppers active. (unplug them if you have to)

                    2. If signal is still noisy, pull the thermistor out and test. (possibly replace thermisitor)

                    3. If it’s not noisy, move the hotend around with the steppers off and see if it gets noisy with motion. go back to 2

                    4. If it’s still not noisy, it’s definitely EMF from the steppers, and you’ll need to replace the wire to the sensor. ideally with shielded wire and try not to run it along the same path as the stepper wires.