A couple of keycaps short, but I’ll move them across from my daily driver (at the top) when the time is right. All soldering is done. I just need to program the firmware. But it’s likely not going to happen until the weekend after next due to other commitments. Can’t wait to try it out though!
Note: the logo didn’t come out quite right, but I’m not going to bother with a reprint as I still don’t know if I’ll like the layout.
You must log in or register to comment.
Which keycaps tilters & keycaps do you use?
The tilters are just ones I found on Thingiverse. Both boards are choc. The caps on the top one are LSDA low profile, while the bottom have MCC POM caps. The thumb clusters on both are using the LSDA thumb keys as they’re nicely angled.
