I am not asking for you to make one, I just search for one, I couldnt fidn anything exacly like this during my research

yea me too, it was just some info for other ppl

Linux with FUTURE WINE is your solution

future wine is just the future versions of wine, specifically the one that will be perfectly able to run windows programs

Wow, exactly like me

No it’s just a stock sprite pro extruder upgrade kit that I bought directly form creality.

Ooh I might PID TUNE it buuut soon I want to go with a stainless steel nozzle. So you know… I will even go with a high flow one.

I already printed a temp tower and NO temps from 220 to 250 worked well

Oh I plan getting the dual z as well lol. I tried input shaping and pressure advance. As far as I am concerned I setup pressure advance and it has been going well.

But with input shaper I did not manage to get it working, but in my current setup I believe it is unnecessary because my enclosure is FAR to wobbly and the printer vibrations goes to the entire house, I plan on printing springy feet and attaching the enclosure to the wall so that it does not move.

So my vibrations is so bad that I need physical upgrades to even get it working… And an accelerometer

Oh don’t worry my z offset is set tight! And for the heat block I always undertihhgened and it leaked everywhere so now I tighten it firmly but not too much to the point of stripping the block

So for the mods:

All in one rear mounted electronics box by Teaching Tech. Glass bed. Skr mini e3 v2. Sprite pro dd extruder. Klipper. Metal bed knobs and springs. PETG printed rear left tension remover. Crtouch. Ikea lack enclosure (not completely done YET). Others I might have missed so I guess it’s not important ¯_( ツ )_/¯

For the crash my hotend just untightened lowering it lower than the bltouch. I use klipper now so the mainboard firmware akaik isn’t responsible for a lot. I have done A LOT of mods which I will list in a reply. For manually level the bed, I just probe 5p times my bed with abl, look at the graph and adjust the knobs in consequence…

Yeah I know it’s hard to troubleshoot without being there,trust me,trust me…

Thanks for your help I guess my filament is better at 280C ¯_( ツ )_/¯

I am French and I state that in fact I do not like France

and porn