There is actually an open source eReader, openbook https://www.oddlyspecificobjects.com/projects/openbook/

Unfortunately, the current screen it uses is not being made anymore. People have stated that they have gotten other screens to work, but no official instructions on using them yet

Zooming into the image, by “all one piece,” they mean the grates and bottom plate, as there are seams along the back wall at about one average bed width apart

I managed to get my order in 36mins after launch (512GB), it has arrived today.

It certainly isn’t a silver bullet l, but considering the amount of data that gets served through CDNs like Cloudflare, it should do something.

That’s a shame, well I guess I’ll keep using it till it stops working. Then I would probably be switching back to Eternity as I used to use Infinity

How liftoff is so far down on that list baffles me

Most viruses now start off by scooping up all saved browser passwords automatically then sending them to a remote server. So if one of those ever goes off on your system you are at quite a risk. Especially since there are really good other options that aren’t vulnerable to that

Assuming the cable works correctly in something like your phone it is possible that some lint or something has built up in the usb c port. This can prevent the cable from being fully inserted and make it feel ‘mushy’. You should be able to clean it out gently with a plastic dental pick.

Ah, noted.

I had this happen on my ender 3 v2 recently as well, a thin layer of washable purple gluestick has solved it for me (though parts are now sometimes a bit difficult to remove and sometimes require a moist rag to get the gluestick residue off)

In my experience this is just how 90° overhangs are. It can’t be perfectly flat because if it was it would fuse to the temporary supports. You might be able to get better results with better fillament cooling (or lower fillament tempatures), but afaik some artifact will always be there. So unless I’m mistaken you can’t really “fix” this issue and you are most likely better off designing around it and adding some extra tolerance when you have to use overhangs like this.