I believe the developer is in complete control of the pricing on steam, so it would be the developer being shady
I believe the developer is in complete control of the pricing on steam, so it would be the developer being shady
you can, yes. it’s called hard drive shucking and is extremely common.
Is it just me or does that “comparison” make no sense for this thread. It’s mostly comparing vaultwarden to the cloud version of bitwarden, not the self hosted version. It only mentions the self hosted version in passing. It doesn’t do anything to help someone choose between vaultwarden and self hosted bitwarden
So a reverse proxy is sort of like a phonebook or directory, it routes outside requests to the appropriate place. So imagine your reverse proxy is a receptionist, someone comes in and says “hey I am looking for plex.mydomain.com” the receptionist would then use the phonebook and say “ok if you are looking for plex.mydomain.com, go to building 192.168.1.10 (the ip), room 9000 (the port)”
Since you are asking about dockerized services, the networking for those can be done in several different ways, but the one thing that really matters is that each service needs to have a unique combination of ip and port, because only 1 service can live at each address. With docker, you could set up multiple services that use the host server’s ip, in which case each container will need to be on different ports, or you could have it so each container has its own ip, in which case the port can be anything.
Think about what happens to water if it’s heated above 100C… it turns into steam! The more water there is in the plastic the more steam there will be, causing the various issues like bubbling. The release of steam also means some of the heat is not being absorbed by the filament, leading to temperature issues as it exits the nozzle
I had a similar issue where it was thin in regular intervals similar to what it looks like in your pics, the issue I had was the extruder gear was clogged up on one side so it wasn’t gripping the filament and slipping until it spun around to the unclogged side and it would extrude normally again.
Look into NUT, Network UPS Tools. It runs in a server/client type of set up. You’d install the server onto the device that has the UPS data connected to it. It then monitors the UPS status and can tell all the clients to shutdown when the UPS is running low.
It’s trivial to create new accounts and emails to verify those accounts. It is not trivial to get a new phone number since virtual numbers are blocked by the verification process.