I don’t use Arch BTW

Trump played the uno reversed card on him ;)

No, I’m pretty sure someone would sue them. Not saying we would all get our money back, but there would be consequences

Hasn’t happened so far, and I’ve heard so many times (since I paid for it 10 years ago) it would

Not really a subscription. I’ve paid (I believe it was 75$) for it 10 years ago and I’m still using it.

Didn’t have any issues with deforming of PETG parts in my car. Yeah, -CF should be handled with care, but there are parts that you might not need to touch, and it will be a bit more resistant to deforming under heat.

Try PETG or PETG-CF

Then it might be flow or inconsistent extrusion. Try doing calibration available in Orca (probably same thing in Bambu slicer).

Looks like the nozzle is too close (z-offset is wrong) or too much filament is extruded (flow rate is too high).

Good for you! I’m still finding it useful and doing exactly what I’ve paid for.

Just checked: I’ve paid 10% of that 12 years ago. Inflation is really bad ;)

Good riddance to them ;)

Also have them convert to €, metric units and driving on the right side of the roads ;)

Also change their units to fully metric, start driving on the right side of the road, and start begging to come back;)

Probably in some, not all companies. Depends on who you have worked for

I have worked in IT for 15 years, and no - the level of surveillance is not the same everywhere.

KE and SE too I think

https://github.com/CrealityOfficial/Ender-3_V3_KE_Klipper/issues/13 They all basically use klipper.

But they said you wouldn’t…

Which is why I did not write „all”. I had Prusa specifically in mind. It’s a shame they have to compete with companies that do not follow the rules as much as they do.