https://www.youtube.com/watch?v=aUJN93I-aEg Large-format 3D printing has been stuck in a frustrating paradox for years. You could have massive build volumes or you could have speed, but rarely both without spending industrial-level money. Consider the Prusa XL with its respectable 360×360×360mm build volume crawling along at conservative speeds, or the Bambu X1 Carbon screaming at 500mm/s but
Half planning a frankenvoron with an old CR10 and a few bits and pieces of extra 2040 I planned on making a control box for it with. How do you find it?
I personally am pretty happy with my 2.4, although I would suggest skipping the cable chains and going to an umbilical. I went the nitehawk route. If you’re going to be printing ASA or ABS add an under bed carbon filter and bedfans. I would also suggest skipping to ACM panels if you plan on big ASA/ABS prints.
If you dig through my comments you can see me talking about it. Mechanical bed leveling, that actually squares the gantary to the bed, and Z calibration make for very consistent first layers.
Afaik the SV08 is Voron derived.
Half planning a frankenvoron with an old CR10 and a few bits and pieces of extra 2040 I planned on making a control box for it with. How do you find it?
I personally am pretty happy with my 2.4, although I would suggest skipping the cable chains and going to an umbilical. I went the nitehawk route. If you’re going to be printing ASA or ABS add an under bed carbon filter and bedfans. I would also suggest skipping to ACM panels if you plan on big ASA/ABS prints.
If you dig through my comments you can see me talking about it. Mechanical bed leveling, that actually squares the gantary to the bed, and Z calibration make for very consistent first layers.