Selfhosters what is the power draw of your entire setup? And have you done anything special to manage it you’d like to share?
Including all network equipment I use around 110kWh of good ol’ 120V 60Hz USA juice per month. Averaging about 215 watts of power draw for my systems. Nothing amazing, but I like to think that it’s a conservative setup for everything I accomplish with it. I’m paying around $25 a month for my setup. None of that includes my work PC or personal PC, just hosting infrastructure.
Other than trying to make sure all power states are available on my server I haven’t done a lot of power conservation.
I’m curious what you all have.
You must log in or register to comment.
the theoretical maximum is 20w, the average is around 5w. its a raspberry pi and some old hdd
Averages 50-70 watts. Includes my main NUC NAS thing and all of my networking equipment.
My empire of dirt is basically nothing. I’m using low powered computers, mostly fanless. The watt meter on the main power bar is like 15W.
I’m actually up at 1am because the two servers I brought online pushed my usage to around 1200W and it was too much for my UPS plus solar battery setup to keep up with. Also I just discovered that my power cable was too high a gauge and it melted to the extension cord, so I had to pry it apart with a screwdriver. Oops.
At full tilt I pull around 2500 watts, but I haven’t been fully up and running in months because I haven’t had enough available circuits in my panel. Just upgraded my home service to 400a so I should be able to run some new outlets this weekend.
Around 5kWh/day.
My Biggest Power drain is my homeserver/hypervisor/nas/whatever (5600G, 64gb ram, 9xHDD) which uses around 3.5kWh.
Wifi is provided by 2x Extreme Networks WS-AP3825i and 2x Ubiquiti UniFi 6 Plus which total to around 660W/h.
My Router is a small dual-nic shuttle pc with a Pentium G4560 drawing like 310W/h
Switching is done by an Aruba 2930F-24G-4SFP+ Switch that consumes 490W/hI could probably squeeze out a few more watts if I replace the HDD’s with higher density ones and virtualise my router but I really dont feel like doing that right now…
~500 watts continuous.
40 watts normal up to 60 watts. That includes modem and router. PC is fanless system.
Around 1000-1200 watt continuously. Still our electricity cost is less then 0.
Anyway my old 11gen dell power edge servers cause the biggest power draw. But I am not ready to upgrade them due to the current memory shortage.
My NAS/home server takes about 180 kWH/year, or 20W on average (costs me about 5 Euro/month). This feels like a lot to me and makes up a good chunk of my total energy usage.
What I did to optimize it is mostly select a “low-power” x86 platform, and limit the number of disks. I also decided not to use TrueNAS because it couldn’t let the disks from going to sleep.
The machine hosts 10 TB of usable storage (+RAID 1), syncthing, immich, file server, Influx DB, Grafana, and a few other services.
Yeah I use Unraid for multiple reasons but being able to spin down disks when not in use was a big factor. I have 6 mechanical drives totalling 56TB of usuable storage so it was important to me they don’t all need to be on at the same time. TrueNAS also comes with some other headaches, I like being able to drop in whatever disk I need to for expansion or replacement.
I like being able to drop in whatever disk I need to for expansion or replacement.
I didn’t move that far away (to Debian + ZFS), so that limitation still remains. Although the addition of Raid-Z expansion should alleviate things quite a bit.
That’s the one thing I don’t like about Truenas. It technically can spin down disks, but there’s no way to force them. You can set the idle timer to 5 minutes, but then it constantly spins them back up again. Now I just power the entire system down with home assistant outside of the usage hours and I can power it up again with home assistant using wake on Lan.
A bit goofy, but it works for me
late but i think i lose the thread. The entire house runs at slightly over 1.5kW, and self hosted equipment accounts around 1.2kW of that. The daily cost is only about £2 though due to solarand batteries.
7 or 8w idle for the server. Comes to about 10eur per year. I couldn’t justify using more without feeling like a hypocrite who also advocates for energy conservation.
Nice
What hardware are you running?
11th gen i3 NUC, headless Debian.
Mine draws around 15-20 watts. I’m mostly using low-power hardware: a Rock 5b as my main server, a 2tb nvme ssd, a 2tb hdd and a Glinet travel router (fine since i live in an apartment).
The NAS itself probably takes most of the power, which isnt logged. My server is a Raspberry Pi 5, so used 1.86kWh in September.
Most of my stuff lives on a cheap hetzner vps so that power is someone else’s problem lol. at home it’s a raspberry pi that’s always on (a few watts) and a bitaxe miner doing about 19W, that’s around 14 kWh a month, like 3 euros here. the gaming pc is the only hungry thing and it stays off, the pi wakes it with wake-on-lan when I actually need it. took me a while to get the bios settings right (erp off, power on by pci-e) but it was worth it.
is mining worth it for you?
money wise no, not even close. it’s a bitaxe gamma doing around 1 TH/s solo, so it’s basically a lottery ticket, the odds of hitting a block are tiny. it costs me like 3 euros a month in power so I treat it as a toy, I like checking the best difficulty it found and it’s a nice way to learn how mining works
I am using a Raspbery Pi 5 8GB as my NAS & homeserver. It is quick and performant enough while having an idle power draw which is not really noticeable on your electricity bill. Very happy with it.
