I will rule with my Bovine demigod, once again!

Aghaghagh what a good name for such a cutie pie, I’ve always thought Baihao would be another good one.

I hate when the captcha starts at 1/10, so much so that I’ll usually just walk away if I can.

and rolls of film

Net is what you catch in the net, and the rest falls away.

And cleaning them might involve some sort of tooth sucker device to suck them clean between meals for all the hard to reach places.

That’s it, bring me the Kandahar cock wrench.

Dot hWhat now?

Oh hey I just picked up a 2ds too for some pokemon adventure.

In my opinion, it ends in nova and the transition from prog to nova with the y is just 🤌

deleted by creator

deleted by creator

Ugh, thanks I hate it lol. You’ll have to pry FF from my cold dead cyber paws.

Mullvad, but I’m running into the same problem more and more.

Agreed, getting stuck in the captcha loop makes me unreasonably irritated lol. Hopefully, it gets resolved for you soon!

Interesting. I use ublock on Firefox and gpt daily. Haven’t had any login issues, also use multiple VPN addresses. I think the only verification I’ve had is the easy checkbox.

How about the episode where Rose was informed she might have received HIV infected blood, and the show tackled the stigma around it while she waited 72 hours for the results.

I don’t know the Bambu model, but I do have an ender 3 and a prusa mk4. The ender 3 out of the box doesn’t have an auto leveler, it is “dumb” and it assumes the level of the bed is correct (if you leveled it right it should be).

Other printers like the mk4 and I’m assuming the Bambu have auto levelers that sample the level of the plate over several points, and then remembers the height of these points. Because it remembers the heights, it can adjust for a bed that isn’t manually leveled, so there’s no need for knobs.

You can get this functionality for the ender with a bltouch. But you’ll have to enable it in the firmware and do some configuration and wiring. It’s not too hard.

We do love the oranges