https://www.youtube.com/watch?v=aUJN93I-aEg Large-format 3D printing has been stuck in a frustrating paradox for years. You could have massive build volumes or you could have speed, but rarely both without spending industrial-level money. Consider the Prusa XL with its respectable 360×360×360mm build volume crawling along at conservative speeds, or the Bambu X1 Carbon screaming at 500mm/s but
$1,200 is Voron and RatRig territory. Vorons cap out at 350 mm3 for build volume and 500mm3 rat rigs are $1,550. I agree that plenty of folks are probably over buy on printers, but if you want this kind of build volume the price seems reasonable - especially for a printer that ships assembled. Personally, I went the Voron route and if I wanted a larger printer I would probably either just make my 350mm taller or go the RatRig route.
That said, high velocity on a large format printer isn’t that useful for big prints IMO. You’re probably going be running a bigger nozzle and laying down wide/tall extrusions, which means you’re probably going to be limited by how fast your extruder can melt plastic. That’s the case on my Voron with a Rapido HF with “only” a 0.6mm nozzle, 0.8mm extrusion widths, and 0.3mm layer heights.
Half planning a frankenvoron with an old CR10 and a few bits and pieces of extra 2040 I planned on making a control box for it with. How do you find it?
I personally am pretty happy with my 2.4, although I would suggest skipping the cable chains and going to an umbilical. I went the nitehawk route. If you’re going to be printing ASA or ABS add an under bed carbon filter and bedfans. I would also suggest skipping to ACM panels if you plan on big ASA/ABS prints.
If you dig through my comments you can see me talking about it. Mechanical bed leveling, that actually squares the gantary to the bed, and Z calibration make for very consistent first layers.
$1,200 is Voron and RatRig territory. Vorons cap out at 350 mm3 for build volume and 500mm3 rat rigs are $1,550. I agree that plenty of folks are probably over buy on printers, but if you want this kind of build volume the price seems reasonable - especially for a printer that ships assembled. Personally, I went the Voron route and if I wanted a larger printer I would probably either just make my 350mm taller or go the RatRig route.
That said, high velocity on a large format printer isn’t that useful for big prints IMO. You’re probably going be running a bigger nozzle and laying down wide/tall extrusions, which means you’re probably going to be limited by how fast your extruder can melt plastic. That’s the case on my Voron with a Rapido HF with “only” a 0.6mm nozzle, 0.8mm extrusion widths, and 0.3mm layer heights.
Afaik the SV08 is Voron derived.
Half planning a frankenvoron with an old CR10 and a few bits and pieces of extra 2040 I planned on making a control box for it with. How do you find it?
I personally am pretty happy with my 2.4, although I would suggest skipping the cable chains and going to an umbilical. I went the nitehawk route. If you’re going to be printing ASA or ABS add an under bed carbon filter and bedfans. I would also suggest skipping to ACM panels if you plan on big ASA/ABS prints.
If you dig through my comments you can see me talking about it. Mechanical bed leveling, that actually squares the gantary to the bed, and Z calibration make for very consistent first layers.